Using The Gauge; Getting Started; Fitting The Batteries - Elcometer MTG2 Guia Del Usuario

3 USING THE GAUGE

a Power: Batteries or USB
including battery life indicator
b Measurement Mode
E-E: Echo/Echo ThruPaint™ (MTG4)
c Calibration Method
d Calibration: Sound-Velocity
e Reading Stability Indicator
f Measurement Units
g Menu Softkey
h Reading Value

4 GETTING STARTED

4.1 FITTING THE BATTERIES

Each gauge is supplied with 2 x AA alkaline batteries.
To insert or replace the batteries:
1 Lift the latch on the battery compartment
cover and rotate anti-clockwise to remove
the cover.
2 Insert 2 batteries taking care to ensure
correct polarity.
3 Refit the cover and rotate the latch
clockwise to close.
The battery condition is indicated by a symbol in the top right of the
display ( ):
Full symbol (orange) = batteries at full capacity

Empty symbol (red, flashing) = batteries at lowest sustainable level

Note: Batteries must be disposed of carefully to
avoid environmental contamination. Please
consult your local Environmental Authority for
information on disposal in your region. Do
not dispose of any batteries in fire.
4.2 CONNECTING A TRANSDUCER
1 Align the red dot on the
transducer plug with the red
dot on the base of the gauge.
2 Push the transducer into the
gauge, ensuring that the
connector is fully engaged.
en-3
R
-
- P-E: Pulsed Echo;
(MTG4)
(MTG4)
- mm, Inch
h
www.elcometer.com
a
b
c
d
e
f
g
+
+