Engaging The Mower Head; Shutting Off The Engine; Operating Tips; After Operation - Toro 58620 Manual Del Operador

Engaging the Mower Head

1. After starting the engine, hold the mower bail
against the handle to start mower head.
2. Push the machine forward to mow.
3. Release the bail to disengage the mower head.
Figure 10

Shutting Off the Engine

1. Release the mower bail.
2. Move the engine on/off switch to the O
position.
3. Wait for all moving parts to stop before leaving
the operating position.

Operating Tips

•
When mowing tall and thick weeds or grass,
operate the machine at a slower walking speed.
•
Frequently remove grass buildup under the mower;
refer to Removing Debris from the Machine (page
19).
•
For best results and increased line life, mow using
the ends of the line by moving slowly through thick
or heavy weeds.
•
Shorter mower lines increase job time. Replace
the mower lines when they are worn to less than
half their original length.
•
Mower head contact with concrete, asphalt, and
harder surfaces may cause premature wear to the
height guide and lines.

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Clean grass, debris, and excessive grease from
the machine to help prevent fires. Clean up oil or
fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
g337012
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.
FF
11