Vision Fitness T600 Manual Del Usuario página 14

TENSIONING THE RUNNING BELT
After placing the treadmill in the position it will be used, the belt must be checked for
proper tension and centering. The belt might need to be adjusted after the first two
hours of use. Temperature, humidity, and use cause the belt to stretch at different rates.
If the belt starts to slip when a user is on it, be sure to follow the directions below.
1) Locate the two hex head bolts on the rear of the treadmill. The bolts are located at each
end of the frame at the back of the treadmill. These bolts adjust the rear belt roller.
Do not adjust until the treadmill is on. This will prevent over tightening of one side.
2) The belt should have equal distance on either side between the frame.
If the belt is touching one side, do not start the treadmill. Turn the bolts
counter clockwise approximately one full turn on each side. Manually center
the belt by pushing the belt from side to side until it is parallel with the
side rails. Tighten the bolts the same amount as when the user loosened
them, approximately one full turn. Inspect the belt for damage.
3) Start the treadmill running belt by pressing the GO buttion. Increase speed to 3
mph (~4.8 kph) and observe the belt position. If it is moving to the right, tighten
the right bolt by turning it clockwise ¼ turn, and loosen the left bolt ¼ turn. If it is
moving to the left, tighten the left bolt by turning it clockwise ¼ turn and loosen the
right ¼ turn. Repeat Step 3 until the belt remains centered for several minutes.
4) Check the tension of the belt. The belt should be very snug. When a person
walks or runs on the belt, it should not hesitate or slip. If this occurs, tighten
the belt by turning both bolts clockwise ¼ turn. Repeat if necessary.
NOTE: Use the orange strip in the lateral position of the side rails as criteria
to confirm the belt is properly centered. It is necessary to adjust the belt
until the edge of the belt is parallel to the orange or white strip.
WARNING!
Do not run belt faster than 3 mph (~4.8 kph) while centering. Keep
fingers, hair and clothing away from belt at all times.
Treadmills equipped with side handrails and front handlebar for user support and emergency
dismount, press emergency button to stop the machine for emergency dismount.
BEFORE USING THE TREADMILL
Perform initial setup and calibrate the treadmill using the auto-calibration
feature found in 'Manager Mode' or 'Engineering Mode'.
NOTES:
• DO NOT stand on the belt while the auto-calibration sequence is in progress.
• DO NOT adjust incline until the initial setup and auto-calibration are completed.
• DO NOT start the treadmill running belt or press any speed buttons
until directed to while tensioning the running belt.
14
TIGHTENS RIGHT SIDE OF ROLLER
BELT IS TOO FAR TO THE RIGHT SIDE
TIGHTENS LEFT SIDE OF ROLLER
BELT IS TOO FAR TO THE LEFT SIDE