Vision Fitness T600 Manual Del Usuario página 7

• Open HARDWARE FOR STEP 3.
3
• Attach LEAD WIRE (4) to CONSOLE CABLE (5) and pull lead wire through RIGHT
CONSOLE MAST (6). After pulling the lead wire through the mast, the top of the
console cable should be connected to the MCB (14).
Detach and discard lead wire.
• Attach CONSOLE BASE (9) to CONSOLE MASTS (3 & 6) using 4 BOLTS (G), and 4
CURVED WASHERS (H).
• Tighten all bolts from steps 1–3.
• Install MOTOR COVER (1) using 2 pre-installed SCREWS (A).
Hardware For Step 3
Description Qty
G Bolt 4
H Arc Washer 4
9
1
A
3
5
4
H
6
G
14
• Open HARDWARE FOR STEP 4
4
• Connect the CONSOLE CABLES (4) and HEART RATE WIRES (7) to the CONSOLE
(11) and carefully tuck the excess cable into the CONSOLE BASE (9).
• Attach the CONSOLE (11) to the CONSOLE BASE (9) using 4 BOLTS (I) and 4
SPRING WASHERS (J) and 4 FLAT WASHERS (K).
Hardware For Step 4
Description Qty
I Bolt 4
J Spring Washer 4
K Flat Washer 4
11
4
K
J
I
9
7
7