Recording The Transmitters, Key-Tags And Memory Cards Of An Installation - Erreka IRTAGPROG Manual Del Instalador

3

RECORDING THE TRANSMITTERS, KEY-TAGS AND MEMORY CARDS OF AN INSTALLATION

Reserve transmitters or key-tags (define their codes)
Codes must first be defined (i.e. reserving entries for
them) before programming transmitters or key-tags;
this is done when creating the new installation, as
described above.
Record transmitters
WORKING WITH THE DATABASE

If the installation is already created and it is
necessary to reserve new entries, use the "Options"
tab in the installation window (see "Replacing,
modifying, deleting or reserving transmitters or key-
tags" on page 43).
O
Do not record transmitters close to a receiver, as this
may activate programming mode and modify the
memory. If there is a receiver nearby, disconnect its
power supply.
1 Open the required installation.
2 Select the "Roller" tab.
3 Select the transmitters to be recorded and click on
the "Record Entries" tab.

This can also be done using "Record entries" in
the > "Options Menu" or by right clicking.
4 If you wish, fill in the user details for the selected
transmitters (optional details).
5 Click on the "Next" button.

This will open up the "Record Transmitters"
screen.
6 Connect the transmitter to the console using the
corresponding cable (see "Console connection" on
page 30).
7 Click on "Record" in the pop-up window.

The transmitter is ready to work in the installation
(provided the memory card is recorded and installed
in the receiver (see "Generate memory card" on
page 42).
IRTAGPROG console and "Roller and Key-Tag Management" application
41