EN
Disconnect the power cord or leave the door open to deactivate the oven during cleaning.
Disconnect the power cord before replacing filters and lights.
CHARCOAL FILTER REPLACEMENT
Charcoal Filter installed in your microwave oven, is
used for non vented, recirculated installation. The
filter should be changed every 6 to 12 months
depending on use.
1. Disconnect power to the microwave oven at the
circuit breaker panel or by unplugging.
2. Remove the vent grill mounting screws.
3. Pull the vent grill away from the unit.
4. Remove the charcoal filter and replace with part
number .
5. Put the vent grill back on unit.
CLEANING AND CARE
OVEN LIGHT REPLACEMENT
Remove the vent grill per charcoal filter
replacement instructions.
1. Remove the light cover mounting screw, open
light light cover by carefully pulling up on the
front edge.
2. Remove the LED bracket and light assembly.
Remove the LED light from the bracket by
removing the mounting screw and replace only
with part 5304499540.
To order parts call 833-337-4006.
3. Re-install LED light to the bracket with mounting
screw. When re-installing mounting screw be
careful not to damage the LED light.
4. Reconnect LED light to the harness and place the
LED light assembly back into the light cover.
5. Replace the microwave oven light cover by
carefully pushing into place and mounting the
screw.
6. Put the vent grill back on unit.
25