To Start The Engine, Electric Start - Husqvarna ST 124 Manual Del Usuario

5. Push the primer 1-3 times to start the booster pump.
Use the booster pump for cold start in low
temperatures.
6. Pull the recoil start handle.
CAUTION: Do not release the recoil start
handle quickly. Move it back to the start
position slowly.
Note: If the recoil start handle has frozen, slowly pull
out as much rope out of the starter as possible and
release the recoil start handle. If the engine does not
start, repeat the procedure or use the electrical
starter.
7. Run the engine 30-40 seconds at idling speed before
you start to throw snow.
1272 - 003 - 09.08.2019
8. When the engine is warm, slowly move the choke to
the OPEN position.

To start the engine, electric start

WARNING: The product has a 120 Volt A.C.
electric starter. Do not use the electric
starter if your house is not a 120 Volt A.C.
three-wire grounded system. Serious
personal injury or damage to the product
could occur. The electric starter has a three-
wire power plug, and is designed to use 120
Volt A.C. household current. Ensure that
your house is a 120 Volt A.C. three-wire
grounded system. If you are uncertain,
consult a licensed electrician.
Note: Use an extension cord that is recommended for
outdoor use, and that is not longer than 50 feet (15 m).
1. Release the drive engagement. Put the drive speed
control lever in the first position.
2. Turn the fuel switch to the ON position.
11