To Assemble The Drive Speed Control Rod; To Assemble The Auger And Driver Cables - Husqvarna ST 124 Manual Del Usuario

Ocultar thumbs Ver también para ST 124:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Use 1 locking nut M8 (A), 1 plastic locking handle
knob (B), 2 curve spacers (C) and 1 screw level (D)
to assemble the chute rotator.
6. Use 1 hexagon nut M8 (E) to fix the chute rotator (F)
into the holes of the handle.
A
B C
To assemble the drive speed control
rod
1. Install the long bent end of the drive speed control
rod (A) to the control panel, and attach it with 1
connecting rod spring (B), 1 flat spacer (C) and 1
cotter pin (D).
A
8
C
E
F
D
B C
D
2. Pull up the shift connecting plate (B) and install the
short bent end of the drive speed control rod (A).
Attach the drive speed control rod (A) with 1 flat
spacer (C) and 1 cotter pin (D).
D
3. If necessary, extend the drive speed control rod.
Loosen the locking nuts of the turn buckle and spin
the turn buckle. Tighten the turn buckle back to its
original location for proper speed control. The
original location is marked on the threads.
To assemble the auger and driver
cables
1. Remove the 2 cable screw bolts (B) from the cables
(D).
C
A
B
1272 - 003 - 09.08.2019

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido