Maintenance; Maintenance Schedule; To Do A General Inspection; To Replace The Engine Oil - Husqvarna ST 124 Manual Del Usuario

Ocultar thumbs Ver también para ST 124:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

On flat surfaces, like asphalt roads, raise the skid
plates up to 5-6 mm (0.2-0.25 in) off the ground.
The scraper bar is reversible. When it becomes worn
almost to the edge of the housing, reverse it.
Replace the scraper bar if it is damaged, or if both
sides are worn.

Maintenance schedule

Maintenance

Make sure that nuts
and screws are tight-
ened
Do a check of the en-
gine oil level
1
Replace oil
Make sure there are
no fuel or oil leaks
Remove clogging,
foreign objects in
auger
Inspect the tire pres-
2
sure
Inspect and change
3
the spark plug
Note: It is not necessary to add grease or to do other
maintenance to the gearbox.

To do a general inspection

Make sure that all nuts and screws on the product
are tightened correctly.

To do a check of the oil level

CAUTION: A too low oil level can do
damage to the engine. Do a check of the oil
level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a correct
picture of the oil level.
1
Replace the oil after the first 20 h, 50 h, 100 h and then every 100 h.
2
See Technical data for correct tire pressure.
3
Check and clean spark plug before use each year.
14
Maintenance
Daily
20 hours
X
X
X
X
Do not dispatch the chute deflector if it is clogged.
If the product does not move forward due to
unforeseen circumstances, release the drive
engagement immediately or move the ON/OFF key
to the "OFF" position.
50 hours
X
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.

To replace the engine oil

1. Run the engine a few minutes to make the oil warm.
Warm oil flows better and carries more
contaminants.
WARNING: The engine oil is hot. Avoid
skin contact with the used engine oil.
2. Put the product on level ground.
3. Run the engine until all fuel has been depleted.
4. Remove the ignition key.
5. Put a container under the oil drain plug.
100 hours
X
X
1272 - 003 - 09.08.2019
X
X

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido