Peg-Perego PRIMO VIAGGIO 4-35 NIDO El Manual Del Propietario página 29

How to install the Base using the LATCH SYSTEM
Push each latch onto the
anchor bar located between
your vehicle seat backrest and
cushion. Press until you hear a
click (e).
Keep the lockoff clip open and make
click
sure that the latch strap is threaded flat
through the base (f ).
Tighten the base against the seat by
pulling the free end of the latch strap;
at the same time press down on the
base with your body weight and tighten
further (g). Push and pull on the base.
If you can move it more than 1 inch
(2,5 cm), tighten the belt further.
- 29 -