How To Install The Base Using A Lap/Shoulder - Peg-Perego PRIMO VIAGGIO 4-35 NIDO El Manual Del Propietario

How to install the Base using a lap/shoulder INFLATABLE BELT
Level the base and open the Right Tight
lockoff clip (at page 28).
Thread the lap portion of the belt through
the slots on the base (d) and lock the latch
plate into the buckle as shown (e). Press
down on the base with your body weight
and pull the shoulder strap up as shown (f).
Close the Right Tight lockoff clip
by pressing the lever as shown in the
picture (f ) with an audible click. Leave the
click
shoulder portion of the belt out of the
base as shown in the picture (g).
Push and pull on the base. If you can move
the base more than 1 inch (2,5 cm), tighten
the belt further. Check the level indicator.
If the bubble has moved outside of the
desired area, turn the knob until it is back
within the correct area. You may need to
loosen the strap slightly to do this.
Warning! If you cannot get the belt tight
enough, refer to your Vehicle Owner's
Manual or call Peg-Perego USA Customer
Service at 1-800-671-1701 for additional
instructions. Your baby is not safe riding in a
loose car seat.
- 35 -