DJI T30 Guía De Usuario página 8

Battery Error LED Patterns
The table below shows battery protection mechanisms and corresponding LED patterns.
LED1 LED2 LED3
In the event of charging temperature protection occurring the battery will resume charging once
the temperature has returned to within the allowable range. If one of the other battery protection
mechanisms activates, to resume charging once the issue has been resolved it is necessary to
first press the Power button to turn the battery off, unplug the battery from the charging device,
and then plug it back in to resume charging.
• DJI does not take any responsibility for damage caused by third-party charging devices.
• DO NOT charge the battery near flammable materials or on flammable surfaces such as
carpet or wood. DO NOT leave the battery unattended during charging. There should
be a distance of at least 30 cm between the battery station and any charging batteries.
Otherwise, the battery station or charging batteries may be damaged by excessive
heating and may even lead to a fire hazard.
• DO NOT charge the battery immediately after flight. The battery temperature may be too
high and may cause serious damage to the battery. Allow the battery to cool down to
close to room temperature before charging. Charge the battery at a temperature range
of 0° to 60° C (32° to 140° F). The ideal charging temperature range is 22° to 28° C (72°
to 82° F). Charging at the ideal temperature range can prolong battery life.
• In scenarios that meet the following two conditions simultaneously, the battery can be
charged immediately after flight:
a. The temperature of the flight environment was below 30° C.
b. The temperature of the charging environment is below 30° C and there is no direct
sunlight.
• DO NOT charge the battery near heat sources such as a furnace or heater.
• Regularly check the terminals and battery ports. DO NOT clean the battery using alcohol
or other inflammable liquid. DO NOT use a damaged battery station.
• Keep the battery dry at all times.
LED4 Blinking Pattern
LED2 blinks twice per
second
LED2 blinks three times
per second
LED3 blinks twice per
second
LED3 blinks three times
per second
LED4 blinks twice per
second
LED4 blinks three times
per second
All 4 LEDs blink fast
Battery Exception Item
Overcurrent detected
The battery system is abnormal
Overcharged detected
Charging device over-voltage
Charging temperature is too low
Charging temperature is too high
The battery is abnormal and
unavailable
7