Connecting The Speakers; Bare Wire Connections - Pioneer VSX-520 Manual De Instrucciones

03 Connecting your equipment

Connecting the speakers

The receiver will work with just two stereo
speakers (the front speakers in the diagram)
but using at least three speakers is
recommended, and a complete setup is best
for surround sound.
Make sure you connect the speaker on the
right to the right (R) terminal and the speaker
on the left to the left (L) terminal. Also make
sure the positive and negative (+/–) terminals
on the receiver match those on the speakers.
If you're not using a subwoofer, change the
front speaker setting (see Speaker setting on
page 38) to LARGE.
Be sure to complete all connections before
connecting this unit to the AC power source.
SUBWOOFER
PRE OUT
CD-R/TAPE DVR/VCR
SURR BACK /
FRONT
HEIGHT
L
( Single )
OUT
R
PRE OUT
CD CD-R/TAPE DVR/VCR
L
IN IN
E
SW
Powered subwoofer
18
En
ADAPTER PORT
( OUTPUT 5 V 100 mA MAX )
VIDEO
DVR/VCR TV/SAT
OUT IN IN
MONITOR OUT DVD IN BD IN
P P Y
L R
Front speakers

Bare wire connections

Front speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
1
10 mm
3
( / in.)
8
Center and surround speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
1
10 mm
3
( / in.)
8
SPEAKERS A
FRONT
R L
SURROUND CENTER
R L
C
Center speaker
2 3
2 3
Class 2 Wiring
SL SR
Surround speakers