Festo CDVI Serie Breve Descripción página 12

2 Multi−pin connection
2.1 Multi−pin plug
Each valve solenoid coil must be assigned to a specific pin
of the multi−pin plug in order that the valves can be actu
ated. A valve position always occupies two addresses on
the base block, irrespective of whether it is fitted with a
blanking plate, separator plate or valve sub−base. The
number of addresses which a valve position occupies in
the expansion blocks depends on the expansion blocks
used.
Bi = expansion block which occupies 2 addresses
Mo = expansion block which occupies 1 address
Occupies 1 address per valve
position:
CDVI5.0−EB...MP−Mo
Caution
The components of the valve terminal contain electro−
statically sensitive elements. The components will be
damaged if you touch the contact surfaces of the plug
connectors or if you do not observe the regulations for
handling electrostatically sensitive components.
Long signal lines reduce the immunity to interference.
Do not exceed the maximum permitted signal line
length of 10 m.
12
Extension blocks
Occupies 2 addresses per valve
position:
CDVI5.0−EB...MP−Bi
Festo CDVI... 0805c English