Pioneer VSX-1020 Manual De Instrucciones página 110

12 Additional information
Symptom
Broadcast stations cannot be
selected automatically, or
there is considerable noise in
radio broadcasts.
Noise is output when
scanning a DTS CD.
When playing a DTS format
LD there is audible noise on
the soundtrack.
Can't record audio.
Subwoofer output is very low. • To route more signal to the subwoofer, set it to PLUS or set the front speakers
Everything seems to be set up
correctly, but the playback
sound is odd.
The PHASE CONTROL
feature doesn't seem to have
an audible effect.
Noise or hum can be heard
even when there is no sound
being input.
Can't select some Input
functions by the INPUT
SELECTOR on the front panel
or the INPUT SELECT button
on the remote control.
There seems to be a time lag
between the speakers and
the output of the subwoofer.
The maximum volume
available (shown in the front
panel display) is lower than
the +12dB maximum.
110
En
Remedy
For FM broadcasts
• Fully extend the FM wire antenna, adjust the position for best reception and
secure to a wall, etc.
• Use an outdoor antenna for better reception (see page 29).
For AM broadcasts
• Adjust the position and direction of the AM antenna.
• Use an outdoor antenna for better reception (see page 29).
• Noise may be caused by interference from other equipment, such as a
fluorescent light, motor, etc. Switch off or move the other equipment, or move
the AM antenna.
• This is not a malfunction of the receiver. The scan function of your player
alters the digital information, making it unreadable, resulting in noise being
output. Lower the volume when scanning.
• Make sure that the input signal type is set to DIGITAL (see Choosing the input
signal on page 60).
• You can only make a digital recording from a digital source, and an analog
recording from an analog source.
• For digital sources, make sure that what you're recording isn't copy protected.
• Check that the OUT jacks are properly connected to the recorders input jacks
(see Connecting other audio components on page 28).
to SMALL (see Speaker Setting on page 101).
• The speakers may be out of phase. Check that the positive/negative speaker
terminals on the receiver are matched with the corresponding terminals on the
speakers (see Connecting the speakers on page 18).
• If applicable, check that the lowpass filter switch on your subwoofer is off, or
the lowpass cutoff is set to the highest frequency setting. If there is a PHASE
setting on your subwoofer, set it to 0º (or depending on the subwoofer, the
setting where you think it has the best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers (see Speaker
Distance on page 102).
• Check that personal computers or other digital components connected to the
same power source are not causing interference.
• Make sure that the Input Skip settings in the Input Setup menu.
• Make sure that the HDMI Input assign in the Input Setup menu then try OFF.
• See Automatically setting up for surround sound (Auto MCACC) on page 37 to
set up your system again using MCACC (this will automatically compensate for
a delay in the subwoofer output).
• Check that the Volume Limit is set to OFF (see Volume Setup on page 105).