Settings - Pioneer VSX-1020 Manual De Instrucciones

12 Additional information
Symptom
Video signals are not output
from the component
terminal.

Settings

Symptom
The Auto MCACC Setup
continually shows an error.
After using the Auto MCACC
Setup, the speaker size
setting is incorrect.
Can't adjust the Fine Speaker
Distance setting (page 90)
properly.
The display shows KEY LOCK
ON when you try to make
settings.
112
En
Remedy
• When a monitor only compatible with resolutions of 480i is connected to the
component terminal and another monitor is connected to the HDMI terminal,
the video signals may not be output to the monitor connected to the component
terminal. If this happens, do the following:
– Turn off the power of the monitor connected to the HDMI terminal.
– Change the VIDEO PARAMETER menu RES setting (page 70).
– Video signals from the HDMI terminal cannot be output to the component
terminals. Input the video signals from the player or other source to the
composite or component terminals. When using the component terminal,
assign it at Input Setup.
Remedy
• The ambient noise level may be too high. Keep the noise level in the room as
low as possible (see also Problems when using the Auto MCACC Setup on
page 40). If the noise level cannot be kept low enough, you will have to set up
the surround sound manually (page 99).
• When using only one surround back speaker, connect it to the SURROUND
BACK L (Single) terminals.
• To use a 5.1-channel speaker set, use the surround speakers for the surround
channel, not the surround back channel.
• Make sure there are no obstacles between the speakers and the microphone.
• If Reverse Phase is displayed, try the following:
– The speaker's wiring (+ and –) may be inverted. Check the speaker
connections.
– Depending on the type of speakers and their installation conditions, Reverse
Phase may be displayed even if the speakers are properly connected. If this
happens, select GO NEXT and continue.
– If the speaker is not pointed to the microphone (listening position) or when
using speakers that affect the phase (dipole speakers, reflective speakers, etc.),
it may not be possible to properly identify the polarity.
• There may have been some low frequency noise in the room from an air-
conditioner, motor, etc. Switch off all other appliances in the room and use
Auto MCACC Setup again.
• Depending on a number of factors (room size, speaker placement, etc.) this
may occur in some cases. Change the speaker setting manually in Speaker
Setting on page 101, and use the ALL (Keep SP System) option for the Auto
MCACC menu in Automatic MCACC (Expert) on page 86 if this is a recurring
problem.
• Check that the speakers are all in phase (make sure the positive (+) and
negative (–) terminals are matched up properly).
• With the receiver in standby, press  STANDBY/ON for about 10 seconds
while holding down SPEAKERS to disable the key lock.