Remote Control Mode Setup; Flicker Reduction Setup - Pioneer VSX-1020 Manual De Instrucciones

11 The system and the other setup

Remote Control Mode Setup

• Default setting: 1
This sets this receiver's remote control mode to
prevent erroneous operation when multiple
units of the receiver are being used.
1 Select 'Remote Control Mode Setup'
from the Other Setup menu.
2 Select the Remote Control Mode setting
you want.
3 Select "OK" to change the remote control
mode.
4 Follow the instructions on the screen to
change the remote control's setting.
See Operating multiple receivers on page 76.
5 When you're finished, press RETURN.
You will return to the Other Setup menu.

Flicker Reduction Setup

• Default setting: OFF
The GUI screen's resolution can be increased.
If you feel the GUI screen is hard to see, try
changing this setting. Note this setting only
affects the GUI screen; it has no influence on
the video output.
1 Select 'Flicker Reduction Setup' from the
Other Setup menu.
2 Select the Flicker Reduction setting you
want.
3 When you're finished, press RETURN.
You will return to the Other Setup menu.
Note
1 If you change this receiver's setting, also change the setting on the remote control.
106
En
1