Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
e)
Do not operate or store the appliance in wet or humid surroundings.
f)
Ensure the sound absorber and air filter work properly. These parts serve as flame
protection in case of misfire.
g)
To avoid possible burn injuries, do not touch the exhaust system or other parts that
become hot during operation. Pay attention to the warnings on the machine.
h)
The engine must not be operated with excessive rotary speed. The operation of the engine
with excessive rotary speed raises the risk of injury. Parts which affect the rotary speed
must not be altered or replaced.
i)
Regularly check for leakage or traces of abrasion in the fuel system, such as porous pipes,
loose or missing clamps and damage to the tank or tank cap. Before use all defects must
be repaired.
j)
Work only in daylight or in good artificial light.
k)
Never pick up or carry a machine while the engine is running
l)
Stop the engine:
•
whenever you leave the machine
•
before refueling
m) Before checking or adjusting the machine, the ignition plug and the ignition wire
respectively must be removed to prevent accidental starting.
Maintenance and storage
a)
Keep all nuts and screws tight to be sure the equipment is in safe working condition.
b)
Never store the equipment with petrol in the tank inside a building where fumes can reach
an open flame or spark.
c)
Allow the engine to cool before storing in any enclosure.
d)
To reduce the fire hazard, keep the engine, silencer and petrol storage area free of
vegetative material and excessive grease.
e)
Replace worn or damaged parts for safety.
f)
If the fuel tank has to be drained, this should be done outdoors.
g)
Always clean and maintenance before storage.
h)
Never disassembly the guards for cutting attachments.
i)
Always store the metal elements in cool and dry place, never use rusted chain or guide. It
may cause serous injure during working.
SPECIAL SAFETY WARNINGS FOR THE TOOL
Keep all parts of the body away from the saw chain when the chain saw is operating.
Before you start the chain saw, make sure the saw chain is not contacting anything.
A moment of inattention while operating chain saws may cause entanglement of your clothing
or body with the saw chain.
Always hold the chain saw with your right hand on the rear handle and your left hand on
the front handle. Holding the chain saw with a reversed hand configuration increases the risk
of personal injury and should never be done.
Wear safety glasses and hearing protection. Further protective equipment for head,
hands, legs and feet is recommended. Adequate protective clothing will reduce personal
injury by flying debris or accidental contact with the saw chain.
40
Publicidad
Tabla de contenido
