Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Caution!
The oil tank should become nearly empty by the time fuel is used up. Be sure to refill the oil
tank every time when refueling the saw.
Check the air filter
Check the air filter to be sure it is clean and in good condition.
Loosen the air cleaner cover screw, and remove the air filter cover, then check the main air
filter. Clean or replace the air filter if necessary.
Starting the engine
WARNING!
The cutting attachement may start to move when the engine is started. Make sure the
attachment can not come into contact with any object.
Make sure that no unauthorised persons are in the working area, otherwise there is a
risk of serious personal injury.
1.
Press the primer (4) several times until fuel begins to fill the bulb.
2.
Turn the ignition switch (27) to the" ON "position.
3.
To start a cold engine, Pull out the choke knob (5) to the start position.
4.
During start the engine, the throttle trigger need not locked in idling position. Don't touch it
during starting.
5.
Slowly pull the starter handle until you feel it engage and then pull it quickly. Return the
starter handle gently and slowly to the original position by hand.
Note: when the engine is started for the very first time. It will require a number of
attempts to start until the fuel has travelled from the tank to the motor.
6.
Push the choke knob to the run positon as the engine started.
7.
After starting the engine, let the engine run for 2 to 3 minutes so that it warms up before
subjecting it to any load.
Under the following conditions the machine must be stop:
1.
When the motor rotary speed changes
2.
When sparks occur
48
Publicidad
Tabla de contenido
