Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8.
The saw chain movement is as indicated by the arrow (Fig. 7). Make sure the chain is
properly placed over the sprocket nose (15) of the guide bar (13).
9.
Pull the guide bar (13) carefully towards the right to tighten the saw chain (14) (Fig. 8).
Fig. 7
10.
Refit the cover (18). Fix it with the retaining nuts (16) (Fig. 9).
WARNING!
Always carry out a test run before starting work and after every tool change! Always ensure that
the tools are in good condition, correctly mounted and able to turn freely. The trial run should be
at last 30 sec.
Adjusting chain tension
WARNING!
The saw chain has very sharp edges. Use protective gloves for safety.
Saw chain tensioning
Always check the saw chain tension before use, after the first cuts and regularly during
1)
use, approx. every five cuts. Upon initial operation, new chains can lengthen considerably.
This is normal during the break-in period and the interval between future adjustments will
lengthen quickly.
Lift up the tip of the guide bar (13) and keep it there as you adjust the tension (Fig. 10).
2)
Fig. 8
Fig. 9
Fig. 10
44
Publicidad
Tabla de contenido
