Fit The Collar Receiver - SportDOG SPORTTRAINER 575 Guia De Inicio Rapido

STEP::05
ADD A COLLAR RECEIVER FOR MULTI-DOG OPERATION
SportDOG Add-A-Dog extra Collar Receiver(s) must be purchased to train additional dogs.
® ®
To add a Collar Receiver for multi-dog training, follow these steps:
1. Program the Remote Transmitter for multi-dog operation:
A. Using the Intensity Buttons (-/+), set the display to 2.
B. Turn the Remote Transmitter over and remove the belt clip (if attached). Using a pen or the tine of a buckle,
depress and release the Mode Button.
C. Using the Dog Buttons (1/2), select Dog 2. After 5 seconds the icon will blink confirming selection.
2. Program the second Collar Receiver (make sure Dog 2 is selected on the Remote Transmitter):
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal
flashing. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Left Side Button on the Remote Transmitter until the Receiver Indicator Light flashes
5 times. If the Receiver Indicator Light does not flash 5 times, start over from A.
STEP::06

FIT THE COLLAR RECEIVER

Please see page 3 of the SportTrainer
Information.
Put the Collar Receiver around your dog's neck and adjust to find the proper fit. Fasten the Collar Receiver so the fit
is snug yet loose enough to allow one finger to fit between the strap and the dog's neck. Fit is important because a
loose collar may cause inconsistent performance.
CONGRATULATIONS!
At this point, your Remote Trainer is ready for field use.
575 Operating Guide for Important Safety
®
SPORTDOG.COM
9