Program The Remote Transmitter - SportDOG SPORTTRAINER 575 Guia De Inicio Rapido

STEP::02
TURNING THE COMPONENTS ON AND OFF
Once charged, the Remote Transmitter is on. Press any button to send signals.
TO TURN THE COLLAR RECEIVER ON
Press and release the On/Off Button. The Receiver Indicator Light will come on and the Collar Receiver will beep
1 - 2 times, depending on what static stimulation range is chosen (the defualt is 2 - medium). To extend the battery
life between charging cycles, turn off the Collar Receiver when it is not in use.
TO TURN THE COLLAR RECEIVER OFF
Press and release the On/Off Button. The Receiver Indicator Light will come on solid red and the Collar Receiver
will beep for 2 seconds. To extend the battery life between charging cycles, turn off the Collar Receiver when it is
not in use.
STEP::03

PROGRAM THE REMOTE TRANSMITTER

The SportTrainer 575 Remote Transmitter has two operational modes allowing you to select the best match for
®
your type or style of training.
NOTE: The Remote Transmitter is factory set to Mode 1.
TO CHANGE THE MODE:
1. Refer to the table on the following page to review the available modes.
2. Using the Intensity Buttons (-/+), set the display to 1.
3. Turn the Remote Transmitter over and remove the belt clip (if attached). Using a pen or the tine of a buckle,
depress and release the Mode Button.
4. Using the Intensity Buttons (-/+), set to Mode 1 or 2. After 5 seconds, your selected mode will flash to indicate
that it has been set.
6
SPORTDOG.COM