Pentair INTELLIBRITE 5G LIGHT Guía De Usuario página 18

14
REMOVING THE LIGHT CIRCUIT BOARD ASSEMBLY
1. Using a 1/4 in (0.64 cm) nut driver, carefully remove the four retainer nuts
from the light assembly (see illustration on next page). Place the nuts aside
for reinstallation.
2. Unplug the two connector plugs from the circuit board. Lift up the circuit
board and remove it from the light housing base.
3. Carefully lift off the old thermal strips from the base of the light housing base
and discard.
Circuit board
connector plugs
Thermal
strip (2x)
4. Place the two new thermal strips (provided) over the circuit board studs in
the base of the light housing.
5. Place the light circuit board over the base studs and seat the circuit board
on top of the thermal strips. Be sure the two connecting wires are not caught
between the housing and the edge of the circuit board.
6. Using a ¼ in (0.64 cm) nut driver, tighten each of the four retaining nuts to a
torque value of 6.0 (minimum) to 8.0 (maximum) in-lbs to secure the circuit board.
DO NOT OVERTIGHTEN THE CIRCUIT BOARD NUTS.
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
Retaining nut (4x)
Circuit board
Light housing
Circuit board
stud (4x)