Tabla De Contenido - Pentair INTELLIBRITE 5G LIGHT Guía De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

II
Technical Support:
www.pentairpool.com and www.staritepool.com:
Web sites:
IMPORTANT WARNING AND SAFETY INSTRUCTIONS............................. iii-iv
IntelliBrite 5G Pool and Spa Lights Overview .................................................... 1
(in an existing pool/after electrical requirements are met) .............................. 2/4
IntelliBrite 5G Pool and Spa Light Fixture Installation
(new pool construction - GFCI Installation Requirements (USA) .................... 5/6
IntelliBrite 5G Pool and Spa Light Fixture Installation
(new pool construction (Canada) ..................................................................... 6
Junction Box/GFCI Installation Requirements (Canada) .................................. 7
Installing the IntelliBrite 5G Pool and Spa Light Fixture
(after electrical requirements are met) ............................................................. 8
IntelliBrite 5G Pool Light (12 V) Fuse Harness Replacement Overview .......... 10
Replacing the IntelliBrite 5G Pool Light Circuit Board Assy (existing pool).......11
Wide and Narrow Angle Lens Adjustment/Part Numbers ............................18/19
IntelliBrite 5G Spa Light Replacement Kit Part Numbers ................................ 24
Before Installing luminaries read the following:
page 19). Failure to do so may permit water to leak into the assembly which
could cause; (a) an electrical hazard resulting in death or serious injury to pool
users, installer, or others due to electrical shock, or (b) breakage of the lamp
or lens, which likewise could result in serious injury to pool user, installers, or
bystanders, or in damage to property.
FOR 12 VAC LUMINARIES: ALWAYS USE A SEPARATE STEP DOWN
TRANSFORMER TO POWER LUMINARIES. SEE DIAGRAM ON PAGE 6. Note:
Connect all three wires to the corresponding circuit wires in the Junction
Box (black wire to power, white wire to common, and green wire to ground).
12 VAC LUMINARIES SPECIFICATION: 50/60 Hz. REPLACE ANY CRACKED
PROTECTIVE SHIELD (CRACKED LENS) WITH NEW LENS AND GASKET.
USING A DIMMER SWITCH WILL RESULT IN PERMANENT
DAMAGE TO THE LIGHT.
P/N 619894 Rev A - 12/2015
INTELLIBRITE
5G Pool and Spa Lights Installation and User's Guide
®
Phone: (800) 831-7133 - Fax: (800) 284-4151
Always install a new Uni-Tension Wire Clamp assembly and
Lens Gasket when reassembling the light assembly (see
THE INTELLIBRITE 5G LED POOL LIGHT AND SPA
LIGHT CANNOT BE USED ON A DIMMER CIRCUIT.
Contents

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido