WLabs ZERA Manual De Uso Y Cuidado E Instrucciones De Instalación página 16

Cleaning the Dust Screen
1.
Dust screen
For proper performance, clean and re-install the dust screen
after each cycle.
The dust screen is designed to continuously remove fine
particles.
The dust screen is removable for cleaning. Follow steps 2
through 6 to remove, clean and re-install the dust screen.
2.
Open lid
Slide the lid open to expose the mixing bin.
3.
Locate the dust screen
Locate the dust screen on the side of the mixing bin.
4.
Remove dust screen
1
To remove the dust screen (1) firmly press the tab until it clicks/
disengages, (2) rotate, and (3) pull it out.
Slide the lid closed after removing dust screen.
2
3
5.
Wash dust screen
Using a soft brush, gently clean the dust screen under running
water or handwash with warm soapy water after each cycle to
remove any accumulated dust.
6.
Re-install dust screen
To re-install the dust screen, insert the bottom tab of dust
screen into the support bracket opening.
Rotate dust screen vertically and push it inside to snap into
place.
16