Electrical Connection - Astralpool LumiPlus MINI 2.0 Manual Para La Conexión Eléctrica

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Quadraled and of the LumiPlus Mini light of RGB LEDs, follow the instructions
provided below:

1. ELECTRICAL CONNECTION

The spotlights are supplied with a 2-wire 1.5mm
You should make sure that the voltage received by the lamp is never more than 12V~AC. The transformer must be able to
supply 6 VA for each led spotlight connected.
2. CONTROL SYSTEMS OF THE LED PROJECTORS: by means of the Colorplus Series
This LED spotlight can be used together with spotlights of the LumiPlus series, whatever its configuration may be (ECO-
TOP).
2.1. Colorplus ECO: NC (normally closed) pushbutton control
The pushbutton of control must support the power of all the projectors that we connect to it. In the case of the pushbutton
with code 32458 it must be connected in the primary one of the transformer and holds a maximum power of 700VA.
The pushbutton control enables you to create different lighting scenarios inside the pool with two function modes:
Fixed colour: Selection of a fixed colour from seven possibilities.
Automatic colour sequence: Selection from among seven programmes of colour sequences. Each programme is defined by
the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE
Each press of the pushbutton changes a colour or sequence. The cycle of colours and sequences is rotary. For example, if
you are in colour 6, by pressing once you will go to colour 7. If you press once again, you will go to sequence 1. If you are
in sequence 7, press once and you will go to colour 2 which is Red.
Colour 1 is white and is reached by one long press.
2.2. Colorplus TOP: control by means of Modulator
The modulator (code 27818) must support the power of all the projectors that we connect to it, the maximum power that it
supports is 900 VA.
The Remote Control – Modulator – Transformer – Led Projector unit enables you to create different lighting scenarios inside
the pool with two function modes:
Fixed colour: Selection of a fixed colour among twelve possibilities.
2 Cu H07RNF cable.
COLOUR Nº
1
2
3
4
5
6
7
1 Red Blue
2 Red Green
3 Purple Cyan
4 Red Blue
5 Purple Cyan
6 Yellow Purple
7 Green Red
(see figure 2 on page 14)
1 Red
2 Green
3 Blue
4 Yellow
5 Cyan
6 Purple
(see figure 1 on page 14)
COLOUR
White
Red
Blue
Green
Purple
Cyan
Yellow
ORDER OF COLOURS
Green Purple
Cyan Blue
Yellow -
Green -
Yellow -
Cyan -
Blue -
7 Sky-blue
8 Pale Violet
9 Orange
10 Magenta
11 Emerald green
12 White
2
Cyan Yellow
Purple Yellow
- -
- -
- -
- -
- -