Manual Installation With Arp/Ping - Axis 225FD Guia De Instalacion

Page 10

Manual Installation with ARP/Ping

1. Acquire an IP address on the same network segment your computer is
connected to.
2. Locate the serial number (S/N) on the AXIS 225FD product label.
3. Open a Command Prompt on your computer and enter the following
commands (appropriate for your operating system):
Windows syntax:
arp -s <IP Address> <Serial Number>
ping -l 408 -t <IP Address>
Windows example:
arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t 192.168.0.125
UNIX/Linux/Mac syntax:
arp -s <IP Address> <Serial Number> temp
ping -s 408 <IP Address>
UNIX/Linux/Mac example:
arp -s 192.168.0.125 00:40:8c:18:10:00 temp
ping -s 408 192.168.0.125
4. Check that the network cable is connected to the camera. Start/restart the
camera by disconnecting and reconnecting power.
5. Close the Command prompt when you see 'Reply from 192.168.0.125: ...'
or similar.
6. Start your browser, type in http://<IP address> in the Location/Address
field and press Enter on your keyboard.
7. See page 12 for instructions on how to set the password.
Notes:
• The ARP/Ping command must be issued within 2 minutes of connecting power to the
camera.
• To open a command prompt in Windows: from the Start menu, select Run... and type cmd
(or command in Windows 98/ME). Click OK.
• To use the ARP command on a Mac OS X, use the Terminal utility, which is found under
Application > Utilities.
AXIS 225FD Installation Guide