Completing The Installation - Axis 225FD Guia De Instalacion

AXIS 225FD Installation Guide
7. Go to the Basic Configuration menu in the Web interface and select
Focus. Follow the on-screen instructions to set the focus.
8. After determining the zoom and focus, lock the zoom puller and the
focus puller in position by rotating the screws clockwise.
Note:
The image can be fine-tuned for low lighting conditions.
Go to 'Setup > Video & Image > Advanced' and refer to the help files for more information.

Completing the installation

1. Check that the safety cord is attached to the hook to prevent the dome
casing from falling off the unit casing during the installation process. Be
careful not to damage the dome or scratch the glass.
2. Rotate the black protective shield inside the dome to match the camera's
position.
3. Clean the dome with a dry soft cloth to remove dust and finger prints
and use a blower to remove dust from the lens.
4. Replace the dome casing and tighten the tamper-proof screws using the
allen key. The installation is now complete.
Page 15