Adjusting The Image - Axis 225FD Guia De Instalacion

Page 14

Adjusting the image

Dome casing
Unit casing
1. Open the Live View page in the Web interface and make the following
adjustments:
2. Loosen the pan adjustment ring and tilt adjustment screws. Hold the lens
while turning the pan adjustment ring, otherwise the lens may rotate
with the lock ring and damage or disconnect the cable.
3. Turn the lens to the desired direction. Do not turn the lens more than
360° as this may cause the internal cables to disconnect.
4. Once satisfied, gently tighten the pan adjustment ring and tilt adjustment
screws to secure the camera's position.
5. Turn the image balance ring to set the image to the correct angle.
6. Loosen the zoom puller counterclockwise, rotate the zoom ring and
determine the desired zoom position.
3 tamper-proof
screws
Zoom
puller
Tilt
adjustment
screw
AXIS 225FD Installation Guide
Focus puller
Pan adjustment ring
Tilt
adjustment
screw
Image
balance
ring