Hyundai i30 Instrucciones De Instalación página 18

Operating instructions for the Dancar Cruise
To activate the system
Turn on the ignition and push "ON / OFF" button to turn the system on. The green LED highlight.
Storing desired cruising speed
To store your desired cruising speed press push the "COAST/SET" button. A "click" is heard from the unit. This is a safety feature. You
must be travelling at a speed above 35 km/h or less than 140 km/h.
The system is tested and approved at speeds between 35 km/h and 140 km/h.
The desired cruising speed is now stored and the vehicle will travel at this speed without need to use either the accelerator or the
brakes.
Changing cruising speed
Each push on the "RES/ACCEL" button will increase the cruising speed by approx. 1 km/h.
Each push on the "COAST/SET" button will reduce the cruising speed by approx. 1 km/h.
If keys are hold down for more than 1 sec., the cruise speed will change until release of the button.
Using the last stored cruising speed. (Memory function)
The system remembers the last stored cruising speed until the ignition or system is turned off.
This last stored cruising speed can be used at speeds over 35 km/h. Pushing the "RES/ACCEL" button will bring the vehicle to the
last set speed.
Increasing speed with the accelerator
When travelling at the set cruising speed, the accelerator may be used to increase the vehicle's speed. A "click" sound is heard from
unit (safety feature).
To de-activate the system
The system can be turned off/pause by pushing the brake or clutch pedal (not with automatic gearbox), or by pushing the CANCEL
button.
When using button ON/OFF for de-activation, the system lose the memory of last stored cruise speed and the green LED turn OFF.
Safety note:
To prevent possible damage to the engine from high revs, store the desired cruising speed in the gear that will be used for
driving at this speed. Do never use the cruise system in congested traffic or on wet slippery road.
If a situation ever arise where system will not disengage according to normal use, you can always turn the ignition to OFF. If
the veichle has a steering lock, be sure it cannot be activated when the ignition key is in the ignition lock or the car is in
gear.
Note: The illumination of the control unit are disabled occasionally. This is not a defect and has no safety or operational
effect.
NOTE: SERVICE OF THE CAR
Access to the car
diagnose connector,
can be done by
temporarily removal of
the D1 diagnose plug.
Dealer stamp:
Green LED
indicator
12
Fig.
OBD
Please find updated instruction : www.dancar.dk
TECNICAL INFORMATION:
Consumption
Dimensions:
Weight:
Supply:
Marking:
Patent:
TÜV/KBA:
User instruction:
18/20
GB
Only illuminated if car is
with Audio remote
20 mAh
82X53X27
57 g.
12 v. dc
E11 marking
PR 176226
90989
Included
Date of installation: