Yakima Jerry Can Manual De Instrucciones página 3

3
INSTALL JERRY CAN ASSEMBLY
Align slots on Jerry Can
Holder with the spring nuts
in Platform slat channel.
Secure the swivel anchor
to Platform using the
following components
in the order shown:
• buttonhead capscrew
• thrust washer
• swivel spacer
• swivel anchor
• wave washer
• thrust washer
Tighten capscrews to 7 Nm
using the provided hex key.
NOTE: Ensure wave washer
is not pinched by the swivel
spacer. A screwdriver can be
used to adjust if necessary.
4
INSTALL JERRY CAN.
Install jerry can into the secured Jerry
Can Holder with the spout upright.
Instruction #6100002960-Rev4 - Page 3 of 8
5
SECURE LATCH.
Feed the loose
strap through the
jerry can handle.
a
A. Hook the
latch end
b
through
the swivel
anchor from
behind.
7 Nm
2X 2X
B. Flip the
outer clasp
over the
latch to lock
it in place.