INSTALLING PROCESS:
GAS CONNECTION:
This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.
This appliance is supplied to run on LPG.
It is the law that all gas appliances are installed by competent persons in accordance with
the current edition of Gas Safety Installation and Use Regulations.
It is in your interest and that of safety to ensure compliance with the law.
GAS SPECIFICATION
GAS TYPE AND PRESSURE
G30 29 mbar
Remove the pan supports, the burner lid and flame
spreader and carefully turn the appliance upside
down and place it on a cushioned mat.
Take care that the ignition devices and flame
supervision devices are not damaged in this
operation.
Apply the sponge provided around the edge of the
appliance. The thickness of the sponge is 3 mm and
the width is 10 mm.
Do not leave a gap in the sealing agent or overlap
the thickness.
Do not use a silicone sealant to seal the appliance
against the aperture. This will ae it difficult to remove
from the aperture in future, particularly if needs to be
serviced.
Place the bracket (B) over the holes that match the
size of the screw. There are one set of screws holes
in each corner of the hob. Slightly tighten a screw
(C) through the bracket (B) so that the bracket is
attached to the hob, but so that you can still adjust
the position.
Carefully turn the hob back over and then gently
lower it into the aperture hole that you have cut out.
On the underneath of the hob, adjust the brackets
into a position that is suitable for your worktop. Then
fully tighten the screws (C) to secure the hob into
position.
HEAT INPUT AND ORIFICE SIZE MARKED (MM)
Wok burner
Rapid burner
3,3kW
(241g/h)
0,93
Semi-rapid
/
1,75 kW
(127 g/h)
/
0,66
Auxiliary - rapid
1,0 kW
(73 g/h)
0,50