Yakima SuperJoe Pro 2 Manual Del Usuario página 3

Attach top hooks.
Attach both top strap hooks (labeled TOP) around top edge of the trunk lid, hatch lid, or rear door.
They should be parallel, and
no wider then the body of the
SuperJoe Pro. Route the straps
over the SuperJoe Pro frame.
If hooks do not fit into the edge
of the hatch or trunk, you can
install the Glass Hatch Hooks.
Remove hooks before
opening the hatch or trunk.
Opening the hatch or trunk
with hooks installed could
cause damage to the vehicle.
OR SPOILERS! USE THE GLASS HATCH ADAPTERS. USE OF THE GLASS
1033613B-3/30
WARNING: DO NOT ATTACH THE UPPER HOOKS TO GLASS, PLASTIC,
HATCH ADAPTERS WILL LIMIT THE LOAD TO TWO BIKES ONLY.
Follow Glass Hatch Adapter installation instructions on page 5.
Adjust straps by
pulling on free end of
straps, or by pressing
the release buttons
on the buckles.
WARNING: Do not pull
upper straps sideways!