Overview Of Your Appliance; Installing Your Appliance; Warnings - Runtal 40016512 Manual De Instrucciones

1.3 Overview of your appliance

ELECTRICAL TOWEL DRYER OR RADIATOR:
This heating appliance is filled with a precise quantity of specific
oil. Any repair work requiring the oil tank to be opened should only
be carried out by the manufacturer or their after-sales service depart-
ment, which should also be contacted in the event of an oil leak.
When disposing of the heating appliance, comply with the regula-
tions in force on the disposal of oil.
This electrical appliance with circulating fluid is delivered ready to use.
It is plugged and filled with a high-performance thermal mineral oil before leaving the factory.
This fluid was specially designed for this use and requires no special maintenance.
As soon as the appliance is switched on, you will notice certain differences compared to a stan-
dard electric heating system:
- the electric heating element heats the fluid, which gradually and naturally starts circulating in
your appliance;
- the properties of the fluid are such that it takes approximately ten minutes for the radiator to
reach its optimum surface temperature, depending on the model and the room temperature when
the appliance is switched on;
- this principle also ensures consistent and sustained heating even when the element is no
longer powered.
DUAL-ENERGY TOWEL DRYER:
This appliance is designed for connection to the central heating system and comes unplugged.
PROGRAMMING:
You can set two separate weekly programmes, P1 and P2 with the remote control.
44

2. Installing your appliance

2.1 Warnings

The flexible cable supplied with your appliance is designed to be
connected to the mains via a junction box that must be placed behind
the appliance, with no need for a plug.
In a kitchen or bathroom, the junction box must be positioned at
least 25 cm from the floor.
The appliance must be installed as described in this document and
in accordance with the applicable European and French standards,
including CEI 60364.7.701 and NF C15-100, as well as the rules of
good professional practice.
For other countries (apart from France), the appliance must be ins-
talled in accordance with standards in force and with rules of good
professional practice in the country of use.
IMPORTANT The example shown only concerns a bathtub. For
other bathroom fixtures, please consult your installer.
IMPORTANT The system must be fitted with an omnipolar circuit-
breaker with a minimum contact opening of 3mm.
40016512 11/2017
Volume 2 Volume 1
0.60 m
Volume 0
45