Setting A P1 And/Or P2 Programme - Runtal 40016512 Manual De Instrucciones

ACTIVATION AND RUNNING PROGRAMMED BOOST (continued)
The expected duration of the boost
is finished.
The appliance returns to normal
boost
operating mode.
The boost will start again the next
day at the same time, as long as
mode
the programme is activated (
icon fixed).
Press
on the
boost key
for 2 seconds.
boost
mode
Note:
The total continuous
operating time for the
boost should not last more
than 2 hours
(120 minutes).
70
You can quit
a programmed boost
at all times by pressing
the boost key.
boost
mode
The programmed
boost is disabled.
The boost will not
automatically start
the next day.
Note:
It is mandatory to
set the starting time to
enable the automatic boost
(see chapter 4).

7. Setting a P1 and/or P2 programme

The setting temperature for P1 and P2 modes is linked to the programming set by the user depen-
ding on the time and day. There are two possible modes for each hour, either COMFORT, or ECO.
WARNING!
The programmes P1 and P2 can have a maximum of 10 changes of mode per day
(from Comfort to Eco or Eco to Comfort).
INTRODUCTION
Short press on
P1P2: back to
previous day.
Long press on
P1P2: back to
previous day, copies
the current daily
programme.
ACCESS TO PROGRAMMING
boost
mode
40016512 11/2017
Program the
current time in
Comfort mode.
Short press on
boost
mode: move to
next day.
mode
Long press on
mode: move to
next day, copies
Program the
the current daily
current time in
programme.
Eco mode.
Long press (P1P2 and
+)  open settings for
programme P1.
Long press (P1P2 and
-)  open settings for
programme P2.
boost
mode
71