Connecting The Appliance; Using Your Dual-Energy Towel Radiator; Use As Central Heating; Use As Electrical Heating - Runtal 40016512 Manual De Instrucciones

2.2 Connecting the appliance

The technical specifications of your radiator are shown on its nameplate.
Please note these down before installing it and before requesting any after-sales assistance.
IP XX
230V ~ XXXXW
XXX–XXX–XXX–XX
OF: XXXXXXXXXX XXXXXX
N CONSTRUCTEUR XXXXXX
When connecting the appliance to the mains, you must observe:
• the voltage indicated on the nameplate;
• conventional colour coding:
– blue or grey: neutral
– brown: live
– black: pilot wire
CONNECTING PRINCIPLE WITH PILOT WIRE:
Your appliance is equipped with a pilot wire for connection to a pilot wire programming base unit
(not supplied with the appliance).
N (blue or grey)
L (brown)
Pilot wire (black)
NOTE:
Your appliance is equipped with an integrated electronic control system so we cannot accept
any liability should the appliance be used with pilot wire programming base units that function by
disconnecting the supply voltage (refer to the instructions supplied with your control unit).
CONNECTING PRINCIPLE WITHOUT PILOT WIRE:
If the pilot wire is not connected, it must be insulated for safety reasons. Under no circumstances
must it be connected to earth.
N (blue or grey)
L (brown)
Pilot wire (black)
48
IP: protection level of your appliance against the
ingress of solid foreign bodies and water spray
Voltage and power required for installation
Appliance reference number
Class II: double insulated
OF: serial number
Manufacturer code
Neutral
Live
Pilot wire (base unit)
Neutral
Live

3. Using your dual-energy towel radiator

IMPORTANT This appliance has been designed to be used ei-
ther in central heating mode or electric mode. Each application
requires special, detailed procedures to be followed. Inappro-
priate use may damage the resistance as a result of excessive
fluid temperatures, particularly in the event of simultaneous use
in electric and central heating modes.
Any inappropriate use will render the contractual guarantee null
and void.

3.1 Use as central heating

Ensure that the control unit is off.
The supply valve must be open to let water from the central heating system circulate.

3.2 Use as electrical heating

A. When using the dual-energy, towel-drying radiator in "electric mode", close the supply valve
only and NEVER CLOSE THE HEATING UNIT'S OUTLET since this enables the fluid to expand
towards the installation.
CAUTION
Closing it may cause excessive pressure to build up with consequential damage to the
heating unit.
B. Ensure that the appliance is sufficiently full by opening the bleed tap at the top. Close it again
if there is a steady flow of water. A sponge and small container should be used for this operation.
If the pressure is inadequate for bleeding the heating unit:
• fill the central heating system with water up to the level indicated on your gauge,
• contact your heating specialist,
• inform the operating company (where heating is collective).
C. To start the appliance, follow the same procedure as for an electric towel-dryer.
If the central heating system is equipped with a circulation pump which is independent of the
boiler, it must in all circumstances be turned off (risk of siphoning the heating unit in the event
that connections are not perfectly watertight).
IMPORTANT: The appliance should only be turned on when properly filled with water (failure to
comply may invalidate the guarantee).
40016512 11/2017
49