GB
•
Take the compactor to where it is required.
•
Having carried out the checks listed in the 'Pre start' section, you may start the engine.
the gearbox.
should be set to maximum.
•
Set the throttle to maximum and use the control handle for direction and to steer or turn the compactor.
During normal operation you should not have to push the compactor but allow it to travel at its own pace.
The speed of travel will be determined by the condition of the surface being compacted.
Caution must be used when operating the compactor in reverse. Ensure that there are no obstructions or trip hazards when
operating in reverse.
compactor's weight. Work up and down a slope not across.
•
Work the compactor over the surface in an organised pattern until the required compaction has been achieved.
Operating Instructions
16