Useful Remote Control Features; Presetting Manufacturer Codes To Control Other Devices; Presetting Manufacturer Codes; Library Search - Pioneer PDP-5080HD Manual De Instrucciones

Useful Remote Control Features

14
Chapter 14
Useful Remote Control Features
Presetting manufacturer codes to control
other devices

Presetting manufacturer codes

1
Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2
Press EDIT and 1 at the same time.
• The LED flashes.
3
Press 0 to 9 to enter the manufacturer code. See page
79.
• Preset mode is finished once the LED no longer lights up.

Library Search

In the event that the device code for a particular target unit is
unknown, you can cycle the remote through the available codes
for that device mode and sample functions from each code in
order to find the code that properly operates the desired target
device.
1
Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2
Press EDIT and 3 at the same time.
• The LED indicator flashes and the remote control unit
enters the Library Search programming mode.
3
Press either SOURCE POWER, PLAY, 1 or CH+ to sample
the selected code.
4
When the code could not be found, press
advance to the next code or return to the previous code
and repeat step 3.
5
Press ENTER when the code that properly operates the
desired target device is found.
• All the available buttons for the selected mode are
programmed in. The remote control unit returns to normal
operation after turning the LED indicator on for one
second for confirmation.
78
En

Manufacturing Reset

You can reset all the learned and preset codes to default
regardless of the mode.
1
Press EDIT and POWER in any Mode switch position at
the same time.
• The LED indicator flashes and the remote control unit
enters the Manufacturing Reset mode.
2
Press D.
• A manufacturing reset is completed. The LED indicator
flashes for one second and the remote control unit returns
to normal operation.
Note
• To exit the Edit mode before it is complete, press EDIT again.
• If the Mode switch selection is changed when in the Edit
mode, the Edit mode is canceled.
• If no operation is performed for more than one minute, the Edit
mode is canceled.
• When you enter a code not listed, the LED flashes quickly.
• The initial mode is "PIONEER".
• You may not be able to control some equipment in the tables
partially or entirely with the supplied remote control unit.
/ to