No Operation Off (Av Source Only); Power Management (Pc Source Only); Sleep Timer - Pioneer PDP-5080HD Manual De Instrucciones

Adjustments and Settings

No Operation off (AV source only)

The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Operation off" ( /
4
Select "Enable" ( / then ENTER).
Item Description
Disable Does not place the system into the standby mode
(default)
Enable
Places the system into the standby mode if no
operation is performed for three hours
5
Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby
mode, a message appears every minute.

Power Management (PC source only)

The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Power Management" ( /
4
Select "Mode 1" or "Mode 2" ( /
Item Description
Off No power management
(default)
Mode 1
• Places the system into the standby mode when no
signal is received from the personal computer for
eight minutes.
• Even when you start using the computer and a
signal is received again, the system stays off.
• The system is switched on again by pressing
STANDBY/ON on the plasma display or TV
the remote control unit.
Mode 2 • Places the system into the standby mode when no
signal is received for eight seconds.
• When you start using the computer and a signal is
received again, the system is switched on.
• The system is switched on again by pressing
STANDBY/ON on the plasma display or TV
the remote control unit.
5
Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to the
HDMI terminal.
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
on
on

Sleep Timer

When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
1
Press HOME MENU.
2
Select "Sleep Timer" ( /
3
Select the desired time ( /
Select "Off" (cancel), "30 min", "60 min", "90 min" or "120 min".
4
Press HOME MENU to exit the menu.
Note
• Five minutes before the selected time elapses, the remaining
time appears every minute.
• To check the remaining time, perform steps 1 and 2. After
checking the time, press HOME MENU to restore the previous
display.
• The SLEEP indicator on the front of the plasma display lights
orange when the sleep timer is set.
then ENTER).
then ENTER).
11
59
En