How To Assemble Your Ceiling Fan - Fanimation NAVY LP7678LBN Manual Del Usuario

How to Assemble Your Ceiling Fan

1. Remove and discard the six rubber motor stops
from the motor assembly by removing the screws.
(Figure 1)
2. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 7. (Figure 2)
3. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 3)
4. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the black, white and blue
(Figure 4)
wires through the downrod.
Motor Assembly
Downrod
Set Screw
Downrod
7
Motor Stop
Figure 1
Pin
Hanger Ball
Figure 2
Figure 3
Black, White
and Blue wires
Set Screws (2)
Figure 4