Fanimation NAVY LP7678LBN Manual Del Usuario página 8

How to Assemble Your Ceiling Fan (Continued)
5. Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 5)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
6. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 6)
7. Reinstall the hanger ball on the downrod as follows.
Route the black, white and blue wires through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball. Pull
the hanger ball up tight against the pin. Securely tighten
the set screw in the hanger ball. A loose set screw
could create fan wobble. (Figure 7)
8. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 8)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
Downrod
Hairpin Clip
Ceiling Canopy
Motor Coupling
Cover
8
Set Screws and
Locking Nuts (2)
Clevis Pin
Figure 5
Canopy Screw
Cover
Figure 6
Figure 7
Figure 8