Worx NITRO WX520L Manual Del Usuario página 11

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
WARNING: Do not release the handle until the
saw blade come to complete stop and do not
touch saw blade while the saw blade is running.
INTENDED USE:
The tool is intended for ripping and cross-cutting wood
and other materials in straight cutting lines, while
resting firmly on the work piece.
Assembly and Operation
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery back
Installing the battery pack
ASSEMBLY
Saw blade assembly and
removing
NOTE: Depress the spindle lock
button to lock or loosen the
blade bolt.
WARNING: Always
remove the battery
before changing the blade!
Cutting depth adjusting
Base plate angle adjusting
OPERATION
Safety On/Off Switch
WARNING: To avoid
cutting injury from the
sharp blade, please don't
put your hands around the
Base Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Rip and Cross Cutting
NOTE: The cutting line of saw
blade is aligned with the
cutting mark 0 .
0
Bevel cuts
Sawdust removal
NOTE: Dust adaptor is sold
separately.
20V Cordelss Brushless Circular saw
Figure
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
See Fig. C
See Fig. D1, D2
See Fig. E
See Fig. F1, F2
See Fig. G
See Fig. H
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduce the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition
and the tooth count of the saw blade. Therefore, use
only sharp saw blades that are suited for the material
being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very fine
cuts into delicate surfaces, diamond for tile, cement
board, etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH CARE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
Periodically clear dust and chips from guard and base to
ensure proper performance.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
of tool and battery is 32 F-113
o
The recommended ambient temperature range for
the charging system during charging is 32
(0°C-40°C).
F (0°C-45°C).
o
F-104 F
o o
EN
11