Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING
Symptom
Tool will not start when operating the
on/off switch.
Cutting depth is less than that is set.
Blade spins or slips.
Blade will not cut a straight line.
Blade kicks back when beginning
a cut.
12
12
20V Cordless Brushless Circular saw
Possible Causes
Battery pack not plugged in.
Battery pack is powered off.
Sawdust accumulated at the rear
of the base.
Blade is not tightly engaged with
the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Blade is not spinning fast enough.
Possible Solution
Check to make sure battery pack is
connected well into a working outlet.
Charge the battery.
Shake out sawdust. Consider connecting
a vacuum for dust collection.
Remove the blade, and reassemble it as
described in Saw Blade Assembly and
Removing section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full speed
prior to beginning a cut in the material.
EN
Publicidad
Tabla de contenido
Solución de problemas
