Klarstein SUMMERJAM Manual Del Usuario página 12

EN
12
ASSEMBLING
Assembling the base
Loosen the screw (16) attached to the bottom of the outer tube (14). Slide the inner
tube (12) into the outer tube and secure the tubes to the base with the screw. Place
the motor housing (8) on the inner tube and secure it with the screws provided.
Make sure the motor is firmly seated on the inner tube.
Attaching the fan and grille
1. Remove the nut from the front of the motor by turning it counterclockwise.
2. Place the rear grille on the front of the motor. The handle should be facing
up so that the mounting pegs on the motor housing engage the holes in the
grille.
3. Tighten the fastening nut clockwise. However, do not overtighten it.
4. Slide the fan blade onto the motor spindle and align the slot on the back of
the blade with the spindle.
5. Tighten the fan cap counterclockwise.
6. Align the front grille with the rear grille so that the holes for screwing are on
top of each other. Slide a bolt through the hole and tighten it with a nut. Do
not tighten it completely yet.
7. Close the locking clips and make sure they are correctly seated on the edge of
the grille. 8.
8. Then fully tighten the nut and bolt on the grille.
OPERATION
Control panel and remote control