Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Device elements
Overview (Fig. I)
1 Mandrel
2 Scale
3 Rocker switch
4 Rear lever
5 Front lever
6 Threaded sleeve
7 Lock nut
8 Mouthpiece
Technical Data
Art.
Stroke
Weight
Length / width
Rivet nuts
Rivet bolts
Weight of the assortment
Operation
Attention!
When selecting the rivet nut / bolt to be set, ensure
that the required grip range is met with respect to
the workpiece.
Otherwise, correct fastening cannot be guaran-
Â
teed.
Inserting the threaded mandrel [fig. I]
▸
Screw the appropriate mouthpiece [8] plus lock
nut [7] into the front threaded sleeve and insert
the threaded mandrel from the rear into the setting
tool.
Initial position of the tool [fig. II]
▸
In the initial position push the rocker switch [3]
upwards.
▸
If the scale [2] is not in the zero position, turn
the rear lever [4]clockwise to set the scale [2] to
zero. When doing so, ensure that both levers are
parallel to each other.
Loading a rivet nut / bolt [fig. II]
▸
▸
Determining the stroke
5964 094 803
process. In this process the stroke determined in trial
can be used as the working stroke.
0 - 8 mm
1.1 kg
200 mm / 155 mm
M4 - M12
M5 - M8
3.5 kg
The stroke is equal to the maximum grip range [Y]
of the rivet nut / bolt minus the material thick-
ness [Z] of the workpiece.
The maximum grip range of the rivet nut / bolt can
be found in the product information for the rivet nut
/ bolt being used.
Tightening [fig. III]
▸
▸
▸
▸
Screw the rivet nut / bolt completely onto the
threaded mandrel [1].
The rearmost thread [X] of the
mandrel must be visible at the
front edge of the rivet nut.
Fix the mouthpiece [8] with the lock nut [7].
The correct stroke is best determined by
reading the value from the scale during
a trial run on a test workpiece.
Set the stroke to zero after each setting
When doing so, ensure that the toggle switch [3]
is in the initial position
.
Insert the blind-rivet nut / bolt in the prepared
workpiece
.
Press the levers [4]/[5] apart from each other
using both hands
and monitor the scale.
Tighten the rivet nut / bolt until the previously
calculated stroke is reached.
9
Publicidad
Tabla de contenido
