Yamaha BRX-610 Manual De Instrucciones página 47

Problem
No picture. Incorrect cable connections.
TV system is set incorrectly.
The power is The sleep timer is set.
suddenly turned off.
[Auto Power Off] is set to [On].
Sound is heard from
Incorrect cable connections.
the speaker on one
side only.
There is noise
This unit is too close to the digital or
interference from high-frequency equipment.
digital or radio
frequency
equipment.
This unit makes a
snapping sound
when starting
playback or loading a
disc.
No sound from the
The subwoofer is not connected properly.
subwoofer.
The level of subwoofer is low.
Sound from the
The subwoofer output level from the unit
subwoofer is too high.
connected to the
SUBWOOFER pre-
out jack is distorted.
The system settings
When [HDMI Control] is set to [On],
change operations of the TV (for example,
automatically. changing channels, etc.) changes the
system settings.
The HDMI control [HDMI Control] is set to [Off].
function does not
The HDMI control function is disabled
work properly.
on your TV.
The automatic The TV does not support the automatic
lipsync is not lipsync.
effective even [Lip
Sync] is set to [Auto].
Cause
Make sure that the cables are connected correctly.
Make sure that the connected TV is set to the correct
input.
Connect this unit to the TV with VIDEO jack using
the supplied video pin cable.
– If picture is still not displayed with this unit
connected to the VIDEO jack, press and hold
for around 5 seconds when no disc is inserted and
playback is stopped to switch NTSC/PAL.
Press and hold
simultaneously for around 5 seconds when no disc is
inserted and playback is stopped to switch NTSC/
PAL. Set resolution properly again when connecting
through HDMI (p. 37).
This is not malfunction. Turn on this unit and play
the source again.
Set [Auto Power Off] to [Off].
Connect the cables properly. If the problem persists,
the cables may be defective.
Move this unit farther away from such equipment.
These sounds are not malfunctions of this unit but
are normal operating conditions.
Check that the subwoofer is connected properly.
Increase the subwoofer level with the SW
(subwoofer) + button.
Decrease the subwoofer output level with the SW
(subwoofer) - button, then increase the subwoofer
level with the control on the subwoofer itself.
Set [HDMI Control] to [Off] or set the system again
by using its remote control.
Set [HDMI Control] to [On].
Refer to the manual supplied with your TV and
check the setting.
Set [Lip Sync] to [Manual] and then manually adjust
the audio output delay.
Remedy
and on the front panel simultaneously
and on the front panel
TROUBLESHOOTING
Page
13
13
13
—
30
35
11
—
—
11
7
7
35
35
—
38
43
En