Cords may also be routed using plastic covers (H).
Route cords inside arm slots of wall arm (A). Lock cords into place by snapping cord corvers onto mount as
4-2
shown in figure 4.3. NOTE: Be sure arrow on inside of plastic covers (H) point toward screen as shown in detail 2.
NOTE: Make sure cords have enough slack to allow full movement of the arm.
Cables may also be secured to slot at bottom of wall plate using a cable tie (L) as shown below.
4-3
DETAIL 2
CORD
8 of 29
ISSUED: 05-09-05 SHEET #: 095-9224-9 12-05-09
H
fig. 4.3
CORD
SLOT
L