Pfannenberg CCE Standart Serie Instrucciones De Operación Y Instalación página 14

CAUTION:
must be quick
•
Switch on the pump; the fluid level must always stay over the miminum level. After the water circuit has run for approx. 5
minutes, switch off the main switch and check again the visual level of the tank; refill the tank in case of need.
•
Switch off the main switch, than switch all circuit breakers to the "on" position and then the main switch back to "On"
position.
•
For 3 phase version fan should be checked for the correct rotation. (Please note that there is an arrow located at the side
part of the fan-shroud for direction indication). Reverse two phases R-S-T on the terminal board in case of incorrect
rotation.
NOTE: for units without fan please verify the correct rotation on the pump motor.
70040-120_01-_-(CCE_Op._Manual_EN-DE-IT-ES-FR-RU).docx
English
Picture 13 – Main switch ON
The pump must not flat running or in inverse direction; therefore the checking of the correct rotation
Picture 14 / 15 – tank top up
14