GreenWorks 2500600G Manual Del Propietário página 11

ELECTRICAL
W A R N I N G
THIS DETHATCHER IS fOR OUTDOOR USE OnLY. DO nOT EXPOSE TO RAIn OR USE In
DAMP LOCATIOnS.
GUIDELINES FOR USING EXTENSION CORDS
USE THE PROPER EXTEnSIOn CORD. Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one of heavy enough gauge to carry the current
your product will draw. An undersized cord will cause overheating. The table below shows the cor-
rect size to use depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge.The smaller the gauge number, the heavier the cord.
**Ampere rating (on tool faceplate)
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
Amp Rating
More Than Not More Than
0
6
10
12
Make sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified technician before use. Keep extension
cords away from sharp objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for tools. This circuit should not be less than #12 wire and should
be protected with a 15 A time delayed fuse. before connecting the motor to the power line, make
sure the switch is in the Off position and the electric current is rated the same as the current
stamped on the motor nameplate. Running at a lower voltage will damage the motor.
W A R N I N G
Although this tool is double insulated, the extension cord and outlet must still be grounded while
in use to protect the operator from electric shocks.
(WHEn USIng 120V OnLY)
25' (7.6 m)
6 18
10 18
12 16
16 14
Total Length of Cord in Feet (meters)
50' (15 m) 100' (30.4 m)
16
16
16
12
9
150' (45.7 m)
16 14
14 12
14 12
not Recommended