Routine Maintenance; Clean The Mopping Module - Dreame Bot L10 Pro Manual De Usuario

Routine Maintenance

EN
Clean the Dust Bin and Filter
1. Open the robot cover, then press the dust bin clip to remove the
dust bin.
2. Open the dust bin cover as indicated by the diagram.
14
3. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush or finger.
4. Rinse the dust bin and filter with water until they are clean.
Thoroughly dry the filter before re-installing.
Note:
• Only clean water should be used to clean the filter. Do not use detergent.
• Before using, keep it in a well-ventilated or cool place.
Routine Maintenance

Clean the Mopping Module

1. Press the two release clips on the side of water tank, remove the
mopping module and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with water only and leave to
air dry before re-installing.
Note: Do not expose the tank to the sun directly.
3. Clean the mop pad with water only and leave to air dry before re-
installing.
Note:
• Remove the pad from the mopping module before cleaning it, and
make sure dirty water does not flow back into the water outlet to avoid
clogging.
• For optimal performance, it is recommended to replace the mop pad
every 3 to 6 months.
4. If slow water flow occurs, or the volume is not well-distributed,
please clean the air hole in the cover of the water tank.
EN
15